Removing scratches and scrapes has never been easier! If you're going for a custom look, the Pryme flap wheel works great for sanding away casting lines too. This wheel has fiber pad in between flaps of sandpaper for smooth and effective material removal.

• Mounts on a die grinder.
• Available in 1" and 2" diameter.
• 1" wide with a 1/4" shaft (best used with a die grinder, can be used on a high speed drill too).
• Offered in grits of 80, 180, and 320.
• Use 80 grit for blending in deep scratches and removal of casting material, 180 grit for light scratches, and 320 grit as a finishing wheel.
• Creates a consistent finish, with little waves or warping.
• Works great for paint preparation too.
• Leaves behind a brushed look, can be further finished with Pryme Cleaning Wheels.
• Max RPM: 25,000.
• Best for aluminum, but can be used on steel, stainless steel, and brass with great results too (steel and brass must be coated afterwards to prevent rust and corrosion).
• Sold individually or in packs of 3, 5, and 10 to save you some cash!

Click on "Video" tab to see the wheel in use.

-Die grinder not included.
-Always wear a dust mask or respirator and proper eye protection while buffing!

Garage Eleven is now stocking Pryme MX finishing and cleaning wheels right here in Australia, so if you are looking to level up your restorations check us out!

Related Items:
Want to purchase the wheels as a set?
Finish your parts further with a Cleaning Wheel.